Page 2 - Desiccant

SPECIFICATIONS DD200 DESICCANT DEHUMIDIFIER

SPECIFICATIONS 10502SS-US FEATURES 10502SS-US
Height 13.3” (340 mm) On/Off Control 4
Width 13” (330 mm) Ammeter 4
Depth 15” (380 mm) Electronic Controls 4
Weight 37.5 lbs (17 kg) Manual / Automatic Mode 4
Voltage Selection
Current 110 V Remote Humidity Sensor Facility 4
Phase 7.5 A Hours Run Meter 4
Frequency Fitted Mains Plug 4
Power 1 Fan Speeds 1
Process Airflow – Dry Air 60 Hz High Capacity PTC Heater 4
Regen Airflow – Wet Air 0.8 kW Process / Regen Air Filter 4
Process Duct Size – Dry Air 115 cfm (196 m3/hr) Rubber Anti-Vibration Feet 4
Regen Duct Size – Wet Air 38 cfm (64 m3/hr) Single, Air Inlet Design 4
Rotor Wheel Speed (rph) 5” (130 mm) Free Standing 4
Noise Level 2.75” (70 mm) Humidistat O
Typical Extraction @ 27°C 60% Carrying Handles 4
Min Operating Temperature 20 Stainless Steel Construction 4
Max Operating Temperature 67 dba Inlet Duct Attachments O
36 ppd (17 lt/day) High Temperature Safety Cut-outs 4
-4 °F (-20°C)
104 °F (40°C)

APPLICATION

Dehumidifiers are required wherever there is a need to lower the humidity level to prevent corrosion,
mold growth and condensation or maintain a low humidity condition during manufacture, packaging
or storing of hygroscopic products.

METHODS OF DEHUMIDIFICATION

Dehumidification is possible using two possible principles, Condensation with refrigeration style
dehumidifiers and Adsorption with desiccant dehumidifiers.

Desiccant dehumidifiers perform exceptionally well when used in cooler climates, or when a low
dew-point, deep drying or low humidity levels are required. Since desiccant dehumidifiers do not
produce water, they will work effectively down to sub zero temperatures.

Their operation is simplistic yet extremely effective and reliable.

Air (Process Air) is drawn into the dehumidifier, where is passes over a wheel impregnated with
Silica Gel. As the air passes over this wheel, any moisture present in the air, is absorbed into the
Silica Gel wheel before leaving the dehumidifier as warm dry air.

The Silica Gel wheel is continually, slowly rotating,
typically at three revolutions per hour. As the
wheel rotates a small portion passes through the
regeneration segment. During this phase a second
air stream (Regeneration Air) is heated to a high
temperature before passing over the wheel. Any
moisture present in the wheel is released into this
air stream, this hot wet air is then exhausted
outside the area being dried.

KEY DESIGN FEATURES

• Stainless Steel Construction
• Auto / Manual Mode Selection
• Electronic Controls
• High Capacity PTC Heater
• Remote Humidistat Facility
• Low Temperature Operation
• Ammeter

PHARMACEUTICAL, CONFECTIONARY, DEFENSE INDUSTRY,
WATER DAMAGE, COLD STORES, POWER STATIONS, PLASTICS